fel kod

[bajen]

jag kan inte ladda mitt m2 det kommer up en ruta som säger Resetting card...
ATR successfully received.
> ATR:3B 24 00 30 42 30 30
Programming Flash...
Error - SW:

:cry: :cry: :cry:

sitter på jobbet undrar om det kan va därför det är ju ett nätvärk..

När jag sätter i kortet i min nya infinity USB så kommer rutan upp att ingen CPU hittades på det isatta kortet rengör kontakterna på kortet och försäkra dig om kontakterna pekar nedåt i progr.....


har för mig att den rutan alltid har kommit upp men kommer ej i håg det va ju en vecka sen den va igång :lol: :lol:


SNÄLLA HELP ME :cry: :cry:

[franniex]

try to update OS. if not the read me file from stopstop below
l FAQ :

Q:
My card is giving me errors while trying to program with this new software.
Old software never gave any problems do you got any hint ?

A:
Try downloading our old soft from :
http://kimianetworks.com/stopstop/M-II_old.zip
Run this old version first ( wont give you picture ) and then again this new soft

Q:
I am getting an error message telling me "Failed to get an ATR" ?

A:
Your programmer isent set to phoenix 3.58 mode

Q:
I am using MP 3.5 programmer and having problems in communication with programmer ?

A:
You need latest firmware for your programmer.
Find it on www.adteknik.se
Also many questions can be answered on their support sites.

Q:
My programmer cant communicate with my M-II card ?

A:
Try to pull your card a few millimeters out of the programmer.
Many M-II cards dont fit 100 % into the cardslot of the programmers.

Q:
I dont own a phoenix programmer whats the best advice for me to buy ?

A:
Infinity USB Phoenix is a very good programmer.
You can buy it from almost any sat-dealers.
Always check out http://www.wbe.dk for latest software for this great programmer.

Q:
I did buy a Infinity USB Phoenix but I see all other cards than a M-II in the software ?

A:
You dont need to set it to M-II card.
Just press the Phoenix button and choose 3.58 Mhz and phoenix.
The software will now be minimized to tray and you can start up M-II.exe and program your card.

Q:
I have another phoenix programmer. Can I use this also or is Infinity required ?

A:
U can use any Phoenix programmer as long as it can communicate on 3.58 Mhz in phoenix mode ( not smartmouse mode )

Q:
I got a phoenix programmer but Windows cant communicate to that programmer ?

A:
Many of the cheap phoenix programmers need external power to run correct ( 9-12 Volt )

Q:
I have put external power on my phoenix but still having problems ?

A:
Change polarisation from your power supply.
Some cheap programmers need + in center and some needs - in center

Q:
I still cant program my M-II card. Anyplace I can get some help ?

A:
You could ask on our board on http://stopstop.mine.nu
Or you could go to IRC chat on http://kimianetworks.com/stopstop/chat/
hope this will help Franniex