DM800 HD se error1 no ca found

[Minime]

Är det en DM800HD se så måste du troligen använda en nyare version av DreamUp

[BenDover]

Är det en DM800HD se så måste du troligen använda en nyare version av DreamUp

använder den senaste, har provat med tre olika, samma problem.

[kir]

Om du inte har så så ladda SIM http://www.dreamoem.com/download/sim...110620_nfi.zip

[Rymmarn]

Saxat från ett annat ställe


First you need a USB-A To mini-usb-B to connect to service socket on back of receiver, and [COLOR=#0033FF !important]a Network[/COLOR] cable to Connect Receiver to PC



[COLOR=#0033FF !important]Download[/COLOR]

1 Sunray -Flashup for 800hdse

http://www.sat-universe.com/showthread.php?t=210717

2 -- Because sometimes a patched image will not do the trick, i did chose for this manual the factory loaded image and the correct SSL82 for this box

Here the All russian image

http://www.sat-universe.com/showpost...01&postcount=8

Here the SSL82 For DM800SE

http://www.sat-universe.com/showthread.php?t=210589

1--- Connect [COLOR=#0033FF !important]USB cable[/COLOR] to service slot on DM800SE/DM500HD and [COLOR=#0033FF !important]USB slot[/COLOR] on Pc. Windows will then install the driver

You will notice, windows created a virtual Com Port connection to be be used ( in this case Com Port 4)


2 --- Switch Receiver off and connect [COLOR=#0033FF !important]Network[/COLOR] cable Receiver and [COLOR=#0033FF !important]Router[/COLOR]

3 --- Then Start SunRay- FlashUp, Tick Use Network, Fill the relevant boxes with local pc IP and Romote ip of your choose and click Connect.

Program will ask for you to Switch on the receiver.

4 -- It will then go into HTTP mode

5 -- At this stage, you open your browser and insert the romote IP shown on the 800LCD

Page will open as per bellow and then you chose the option Update [COLOR=#0033FF !important]Firmware[/COLOR].

6 --- Click Browse and navigate to your image

7 --- Chose the image and click Open

8 --- Now click Flash button

9 --- Image will start to

10 --- When it finishes you can click the back button of your browser so we can then send in the bl82 do not reboot

11 Browse and select the SSL82 for your DM800SE Clone

12 --- Once again Click Flash


13 -- After finishing click Reboot. In Most case you will need to do so manually



Box will then reboot and come back to life with image we chose to load. Then you can load your Patched image of your coice as box is functional again



Thanks Joedenoble

Hoppas det funka